Ergotron WorkFit-B Guía de usuario descargar pdf (Pagina 9)

9 of 18

888-24-227-G-00 rev. B • 07/13

M5 x 6mm

16x

#12-14 x 5/8”

WARNING

Keep Brake Cables Away from

Sync Rod and Crossbars

During Installation!

Failure to keep the brake cables away from

sync rod and crossbars may restrict lift

motion and may cause equipment damage

or personal injury! Refer to instruction

manual for more information.

Use a Phillips screwdriver to insert the provided M5x6

mm screws into the two crossbars connecting the left

and right legs. Make sure the brake cables don’t

loop around the crossbars.

Tighten the screws slightly one at a time

and repeat to ensure that the tension

on every screw is equal.

Partially insert 9 of the provided #12-14 wood screws

in the left leg and worksurface.

Set the left leg (without

hand brake) upright on the

worksurface.

Attach the left end of the

sync rod to the left leg.

Make sure the brake cables

don’t loop around the sync

rod. See Warning, right.

Use a Phillips screwdriver to tighten

down the screws attaching the legs to

the worksurface.

NOTE: Do not overtighten screws.

overtightening screws may result in stripping

the holes and may cause the installation to be

unsafe.

NOTE: Do not overtighten screws. overtightening

screws may result in stripping the holes and may

cause the installation to be unsafe.

NOTE: Do not

fully insert

the screws

into the work-

surface at this

time. Leave

approximate-

ly 1/8” space.

Set-up Steps

Front =2 screws

Middle = 3 screws

Rear = 3 screws

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Comentarios a estos manuales

Sin comentarios

Ergotron WorkFit-B Guía de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Escritorios De La Computadora Ergotron WorkFit-B