Ergotron WorkFit-B Guía de usuario

888-24-228-G-00 rev.B • 07/131 of 15User's Guide - EnglishGuía del usuario - EspañolManuel de l’utilisateur - FrançaisGebruikersgids - Nederlands

888-24-228-G-00 rev.B • 07/1310 of 15a b 910Set-up Steps

888-24-228-G-00 rev.B • 07/1311 of 1511abcSet-up StepsRemove the stop screw to allow the worksurface to raise and lower before installing equipment.Af

888-24-228-G-00 rev.B • 07/1312 of 15827-178-00Minimize Lift Strength BEFORE: -Removing Mounted Equipment-Shipping the Cart-Storing the CartInstall St

888-24-228-G-00 rev.B • 07/1313 of 1514mmWARNING. Before removing mounted equipment (monitor, arm, stand CPU, etc.), from desk, or to prepare for ship

888-24-228-G-00 rev.B • 07/1314 of 15APPENDIX B - Inserting Stop ScrewWARNING. Before shipping or storing the desk, or in cases where the desk is plac

888-24-228-G-00 rev.B • 07/1315 of 15Learn more about ergonomic computer use at:Más información sobre el uso ergonómico de ordenadores:Apprenez-en plu

888-24-228-G-00 rev.B • 07/132 of 15777-24-027-G-00These symbols alert users of a safety condition that demands attention. All users should be able to

888-24-228-G-00 rev.B • 07/133 of 15827-178-00Minimize Lift Strength BEFORE: -Removing Mounted Equipment-Shipping the Cart-Storing the CartInstall Sto

888-24-228-G-00 rev.B • 07/134 of 15AB C12341/4” 14mm1x1x1x2xØ 1/8" (3 mm)Ø 5/32" (4 mm)Ø 1/4" (6.5 mm)Ø 15/32" (12 mm)16x4xM2

888-24-228-G-00 rev.B • 07/135 of 15FRONT OFWORKSURFACEFRONT OFWORKSURFACE113.15" (334 mm)18.9" (480 mm)Set-up StepsPlace template on bottom

888-24-228-G-00 rev.B • 07/136 of 15FRONT OFWORKSURFACEFRONT OFWORKSURFACEFRONT OFWORKSURFACEa b 321x16x3/8" (10 mm)5/32" (4 mm)Ø 5/32&quo

888-24-228-G-00 rev.B • 07/137 of 15FRONT OFWORKSURFACEFRONT OFWORKSURFACEFRONT OFWORKSURFACEcd 41x4xØ 1/4" (6.5 mm) Ø 15/32" (12 mm)Set-u

888-24-228-G-00 rev.B • 07/138 of 155616x1x16xM2.9 x 7mmM2.9 x 7mm1x#12-14 x 5/8”Set-up Steps

888-24-228-G-00 rev.B • 07/139 of 1587a a b b 5/16" (8 mm)Ø 1/8" (3 mm)4xST3.9 x 16mmSet-up StepsDrill holes into bottom of work surface 5/