Ergotron WorkFit-D Manual de usuario

1 of 14888-24-205-G-03 rev. E • 12/12< 65 lbs. (29.5 kg)Reduce.Reuse.RecycleENGLISHWorkFit-DMax weight 65 lbs – 29.5 kgCAUTION: DO NOT EXCEED MAXI

10 of 14888-24-205-G-03 rev. E • 12/121413826-901-00WARNINGMoving Parts Can Crush And Cut IMPACT HAZARDFailure to heed this warning may result inserio

11 of 14888-24-205-G-03 rev. E • 12/12=14mm14ENGLISHRelease the hand brake (on the right leg) and move the worksurface up to highest level.Push in the

12 of 14888-24-205-G-03 rev. E • 12/12=14mmENGLISHAPPENDIX A - Minimize Lift TensionWARNING. Before removing mounted equipment (monitor, arm, stand CP

13 of 14888-24-205-G-03 rev. E • 12/1212ENGLISHAPPENDIX B - Inserting Stop ScrewsWARNING. Before shipping or storing the desk, or in cases where the d

14 of 14888-24-205-G-03 rev. E • 12/12Set Your Workstation to Work For YOU! Con gure su estación de trabajo para que trabaje para USTED. Ajustez votr

2 of 14888-24-205-G-03 rev. E • 12/12826-901-00WARNINGMoving Parts Can Crush And Cut IMPACT HAZARDFailure to heed this warning may result inserious pe

3 of 14888-24-205-G-03 rev. E • 12/121234✓ENGLISHWARNING! TIPPING HAZARD!When mounting accessories to the WorkFit-D, they must stay within the foot pr

4 of 14888-24-205-G-03 rev. E • 12/121/4” 14mm1x1xM5 x 6 mmM2.9 x 8 mm17x2x3x3x16x2x1x1xENGLISHComponentsTools NeededSync RodCrossbars# 12-14 Wood Scr

5 of 14888-24-205-G-03 rev. E • 12/128x123ENGLISHPlace the worksurface on a clean  oor with the top side facing down.Carefully position the leg with

6 of 14888-24-205-G-03 rev. E • 12/129x16xM5 x 6 mm6547WARNINGKeep Brake Cables Away from Sync Rod and Crossbars During Installation!Failure to keep t

7 of 14888-24-205-G-03 rev. E • 12/123x3xM2.9 x 8 mm2x89ENGLISHCapture the brake cable in the cable clip as illustrated, then use a Phillips screwdriv

8 of 14888-24-205-G-03 rev. E • 12/121011ENGLISHSet the desk upright onto its legs.CAUTION!LIFT HAZARD!Two persons are required for this step. Failure

9 of 14888-24-205-G-03 rev. E • 12/121212ENGLISHRemove the 4 brake stop screws before installing equipment.Remove the 2 stop screws from the legs then